95 results in 0.0666 seconds.
-
I copied it short after it appeared on the market to save the original.... -
Peter, read the last sentence of Garth's #1....Leave a comment:
-
IMHO the gap between the wheels and the wheel arches is a bit big yet.
RolandLeave a comment:
-
If you use a resin copy of the SCX body the noticeable effect will be a very good handling because the resin body is really very thin, thus lighter -...Leave a comment:
-
No matter if for a home track or a club - an electronic controller is the best choice. Compared to a resistor controller it is like the balance between...Last edited by walker; March 22, 2022, 06:27 AM.Leave a comment:
-
A short note or request and the translation would have been done simultaneously to the German text.
RolandLeave a comment:
-
I wish you a speedy recovery !
Roland...Leave a comment:
-
Thanky you very much for your kind comments.
The Audi is not the fastest. But its performance was by far the best. One reason is that I try to design...Leave a comment:
-
Heavy Metal Slotcar
Heavy Metal Slotcar
Yes, that´s right. I hav built a really heavy model.
All that began with an idea. I found three different...Last edited by walker; February 19, 2022, 08:56 AM. -
Although I´m not Ed :
15x12x10 mm, as I wrote above, are the N-20 motors. Take into account the shaft is only 1 mm dia.
First and...Leave a comment:
-
Photos of what, Lloyd ? The track has been shown here already more than once. The people don´t want to be shown in public. What I will show somewhen...Leave a comment:
-
Back to more fun again
I did not want to tell it before there wasn´t enough to talk about :
After hatching the idea for a long time meanwhile, I am lucky enough... -
And here a picture that shows one of the optimistic attempts to use these motors. In 43rd scale drag races. Too little power and rpm.
Motor screwed...Leave a comment:
-
Thank you, Peter. A good starting point for me, a ratio 1:2.5.
The lifelike motors are not worth the money for being used in 43rd cars -...Leave a comment:
-
Finding the right motors ?
No problem. Insert the motor type, the voltage, the rpm, the mag type.
RolandLeave a comment:
Leave a comment: