500 results in 0.0750 seconds.
-
Ooh where did you find that file? -
I do the same thing on my sidewinder builds. A very slight angle helps overcome the motor/ axle, interference issueLeave a comment:
-
Waiting on ebay. It has been a couple of years since I used my account to sell anything. When I went to post these, ebay no longer allows you to use... -
Had the Gulf colours out. A 908 and a Lotus 30
...Leave a comment:
-
Here is another Lotus 40 file printed out. This is revision 9
...Leave a comment:
-
Here is some pictures of the entry I have decided on. Last ditch effort at trying to make it as quick as possible prior to sending it off.
...Leave a comment:
-
I have been painting aluminum duct tape and cutting it into strips, but I really like the texture of that nylon material you are using. I will have... -
Hi Chris
What are you using for seatbelts? -
I am glad it worked out for youLeave a comment:
-
LED are sensitive to over voltage. Because you did have it working for a time , that would indicate you are close. Try a 68 ohm resistor, and see if...Leave a comment:
-
I got around to doing up Foyt ‘s Lotus 40
3 D printed in resin with a FDM printed chassis.
...Leave a comment:
-
I have had success printing sidewinder spur gears in PTEG. I sometimes print the gear and rear wheel as one piece in an effort to narrow the rear track...Leave a comment:
-
Great finishing on this iconic car. Missed this post until today, but am glad it resurfaced so I could view the great job you have doneLeave a comment:
-
Here is the chassis sans running hardware.
chassis has no frame around the pod allowing rear wheels in tight . This was made specifically...Leave a comment:
-
I have a 3d printed Ferrari racing in the Can Am proxy. Uncompetitvely, but that has more to do with my tuning then it does the body I think
...Leave a comment:
Leave a comment: