Tweet
I may repop the body in resin to decrease weight. Open face helmeted driver is from a similar scale 60s Zee Toys Hong Kong Honda F1 cut in half. Fixed keel guide is from a 1/40 scale Cox Super Scale car. Racing will be crash and burn, last man standing style.
-
Mocking up a few of these 2.4Ghz RC proportional speed control jalopy racers for a 1/43 demolition derby style intersection figure 8 track built from 50+ year old Eldon track. Using bulk Chinese gears, low voltage/high rpm Chinese motors, brass eyelets for rear axle bearings, Motor will be attached to diecast chassis with hot glue/shoe goo. I will cut the axle in half to install spur and reassemble with a press fit brass sleeve.
I may repop the body in resin to decrease weight. Open face helmeted driver is from a similar scale 60s Zee Toys Hong Kong Honda F1 cut in half. Fixed keel guide is from a 1/40 scale Cox Super Scale car. Racing will be crash and burn, last man standing style. -
nice project!
that is a tiny motor for a diecast body car.
will you run the car off the batery? runnibf time? -
15-20 min off a 1s lipo or with a guide off rails with power set at 3-4 vdc.Comment
Comment