Revoslot Proxy RAA. Rules and Registration

[Austin]

• This is Proxy is designed for the Revoslot Chassis with the ability to use the factory Revoslot bodies listed below and the following non Revoslot bodies.
  
  LOTUS ESPRIT GT2 5 points use the Scalextric Lotus Evora GT4
  SALEEN MUSTANG GT2 5 points scalextric 2005 is with wing added
  VENTURI 500 LM GT2 5 points fly 500 or 600
  CALLAWAY CORVETTE CL1 GT2 5 points Ninco
• Repaints of Revslot bodies, must be a good paint job with decals. 3 points
  
  Fees are $25 [email protected] by May 1st
• Cars by, see after I get all the tracks lined up.
  Entry fee per participant is and is due by
  • Cars are to be mailed to
  • Don Pearson
    9 bowers landing
    APT 103
    Merrimack,NH 03054
  • Models Allowed
  • Any of RevoSlot’s models are allowed.
    • Porsche GT2
    • Marcos LM600
    • Dodge Viper
    • Toyota Supra
    • Ferrari F40
  • Body
  • No modifications to the exterior of the body is allowed.
  • Revoslot glass must be used. 3D lexan interior maybe used in place of Revoslot interior
  • The lexan cockpit and the windows may be Shoegoo’ed in place to keep them secure.
  • Body must start every race with all major parts intact including windows and wings.
  • Antennas, mirrors, wipers, tow hooks, and other small, protruding parts from the body are not required.
  • Wings must always be in place at the start of every heat. The wings must be held on securely with glue or tape, so they will not fall off during a heat. There will be no penalty for losing a wing during a heat.
  • If white body kit is used, exterior of body must be painted with at least one coat of paint.
  • If white body kit is used, the body must have numbers displayed on both sides and the top of the car.
  • The use of the rubber body bumpers is optional. These can be Shoegoo’ed in place.
  • Body screws must be stock; they can be taped over to prevent loss during the race. The tape may not control body or pod movement.
  • Rear lower valance may be removed for track clearance if needed
  • Non Revoslot bodies are to be secured using the factory holes and may not be modified.
    Non Revoslot bodies are to use original windows and glass
  • lexan interior may be used without the chassis being seen inside the car
    
    
    Chassis
  • No modifications to chassis are allowed except to adjust wheelbase for non Revoslot bodies if needed.
  • Modifications to the chassis float is allowed.
  • All chassis screws must be stock and be in place at the start of every race.
  • Front and rear axle holders cannot be modified in any way.
  • Front and rear bearings are free choice.
  • Only Revoslot stock guides are allowed 7mm or 9mm
  • No REVOSLOT TOYOTA GT-ONE or LMP chassis
  • Pick-up braids are free choice.
  • Traction magnets are not allowed.
  • Ballast may be used and secured on the chassis but not on the out side.
  • Lead wires are free choice.
  • 1.09 minimum ground clearance to start the series
  • Motor
  • Only the stock RevoSlot motor is allowed.
  • Modifications to the motor are not allowed.
  • Motor Pod
  • Only the stock RevoSlot motor pod is allowed.
  • Sanding the motor pod in any way is not allowed.
  • Modifications to the motor holder are not allowed.
  • All motor pod screws must be stock and be in place at the start of every race.
  • Any Revoslot motor pod float bolts maybe used.
  • Gears
  • Only the RevoSlot 33t spur gear and 12t pinions are allowed.
  • Gear ratio is set.
  • The gear mesh can be adjusted using the motor holder.
  • Modifications to spur gear and pinion are not allowed.
  • Wheels
  • Only the RevoSlot wheels are allowed gen 1 cars may change to the wide Revoslot rear wheels
  • Only the stock wheel inserts are allowed.
  • Modifications to the wheels in any way are not allowed
  • The front wheel track must not exceed the factory contour of the fenders.
  • The rear wheel track must not exceed the factory contour of the fenders.
  • Axles
  • Only 3mm axles are allowed.
  • Tires
  • RUBBER ONLY
  • Only RevoSlot rear tires are allowed, any shore that is available.
  • Tires may be trued, glued and have their edges rounded.
  • Front tires may be trued, polished or hardened
  • Track Power
  • The series will be raced between 10-12 Volts at the hosts discretion
  Points will be awarded in descending order based on the number of entries with 1 additional point awarded to the top qualifier of each round.
  
  Tracks:

Rules thanks to Brumos RSR

[Austin]

1. Brumos RSR #33
2. Doubl-B #5
3. Austin #70
4. docdoom #62
5. #38 for You
6. ALS #65
7. cj74 #29
8. steeveew #24
9. REL13 #90 paid
10. BigDuhg
11. gsnopoint

[Doubl-B]

Austin
I’m not too familiar with GT2 or revo slot cars. Are you saying it is a GT2 proxy but you must use RS chassis? Thus the extra points for certain bodies. I looked at some websites and only found RS cars for the Porsche 911, Porsche GT-1, Marcos and Viper. Nothing for Saleen, Lotus, Venturi or Calloway. Are these cars you can build if you find a body?

And if post #2 is the start of the driver list, I’ll take #5.

thx

BB

[Brumos RSR]

The Marcos and Porsche 911 are GT2 cars. The Viper is on his list, we will see on the F40 and Supra. The Porsche GT1, the Ferrari 333 and Toyota One would not be eligible based on what I’m reading. I believe Austin is saying you can put the other bodies on a Revoslot chassis to race in the proxy.

[docdoom]

docdoom #62

[dungeonracer]

#38 for me

[ALS]

ALS 65 Thanks Great

[Austin]

Austin
I’m not too familiar with GT2 or revo slot cars. Are you saying it is a GT2 proxy but you must use RS chassis? Thus the extra points for certain bodies. I looked at some websites and only found RS cars for the Porsche 911, Porsche GT-1, Marcos and Viper. Nothing for Saleen, Lotus, Venturi or Calloway. Are these cars you can build if you find a body?

And if post #2 is the start of the driver list, I’ll take #5.

thx

BB

Yes if you replace the RS body with one of the others you will get extra points for your work. I know scalextric makes the Lotus and Fly makes the Venturi 500 and 600 same body and ninco makes the Callaway.

[cj74]

I'd like #47 please.

[steeveew]

I'm in, #24

Steve

[Austin]

Rules updated thanks to Brumos RSR

[Austin]

Saleen Mustang GT2 1997 LM Teams for GTR2


Lotus Esprit GT2



VENTURI 500 LM GT2



CALLAWAY CORVETTE CL1 GT2

[cj74]

Anyone know where I can find a Mustang Saleen body? I would very much like to give it a go.

[docdoom]

number change to 62 please was going to do a repaint but changed my mind.

[REL13]

Austin, Could I please have number90. Thank you

[Brumos RSR]

Cars and parts can be purchased at
www.slotcarcorner.com
www.cloverleafracing.com
www.132slotcar.us

[Doubl-B]

Any chance that people who already own RevoSlot cars could publish the wheelbases? I know the Fly Venturi is a pretty short car. But if you bought a RS Porsche 911 thinking you could re-body to a Venturi and it doesn't fit, that would be an expensive oops!
thx.
BB

[cj74]

You can check out Pendle for specs. For now that is the only place I could find for quick reference.

[Brumos RSR]

78.38 mm for the F40

74.5mm Porsche GT2

[cj74]

I need to hedge my bets here... The #47 will be a repaint with decals that I plan to purchase.

Please change me to #29 for now. That way I have a predone livery to fall back on.