Announcement

Collapse
No announcement yet.

3D Slotcars 1/32 NASCAR Truck Bodies

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3D Slotcars 1/32 NASCAR Truck Bodies

    Based on suggestions from other builders, I picked one up. Very pleased.

    -Harry


  • #2
    That must be new. I bought the SRX body. I have the decals to do Bill E. Purple car.

    Click image for larger version

Name:	IMG_2161.jpg
Views:	167
Size:	2.65 MB
ID:	152479 Click image for larger version

Name:	IMG_2162.jpg
Views:	161
Size:	2.66 MB
ID:	152480
    Robert- Shoreline Model Raceways Club
    Connecticut, U.S.A.

    Comment


    • #3
      I guess it is, just saw it on the site.

      Late Models inbound.
      -Harry

      Comment


      • #4
        OK - that is just too NICE! I just ordered one up to do a build on myself!
        Appreciate the heads up Harry!

        Comment


        • #5
          Yup, resin printing can be basically paint ready. Pretty nice.
          Come Race at The Trace!
          Timberline Trace International Raceway - SW of Mpls, MN
          https://www.thingiverse.com/chappyman66/designs

          Comment


          • #6
            I just need to find the printer that can do it
            -Harry

            Comment


            • #7
              Thanks for sharing Harry. I was looking at those truck bodies on eBay. Easy decision now! 👍
              Mike - Galena Ohio

              "When you're back there with the squirrels, you're bound to get your nuts cracked." - Graham Rahal

              https://www.hrwforum.com/forum/hrw-a...gends-bullring

              Comment


              • #8
                HomeRacingWorld Harry, almost any resin printer can do it now. It's just a question of print orientation...my resin printer is small enough that I have to angle bodies or stand them on end except for the small 50s cars. A larger Saturn or equivalent will let you print 1/32 flat on the plate, although that may or may not work well for a variety of technical reasons.

                It's all about how much you want to print.....if you print a LOT, it's cheaper than buying bodies. If you only do a few here or there, not so much.
                Come Race at The Trace!
                Timberline Trace International Raceway - SW of Mpls, MN
                https://www.thingiverse.com/chappyman66/designs

                Comment


                • #9

                  Comment

                  Working...
                  X
                  UA-149438709-1