Carrera digital male/female connectors

[Eric P]

Currently, I have what I think are the JST PH 2.00 mm connectors. I bought them so long ago, I'm only guessing at this. They are the ones that fit the light circuit.
Does anyone know what the power/motor connector is called? Has anyone found a source? I know I can hardwire, but I like the interchangeable system using plugs. Cannabalizing good chassis for wiring is not my long term choice.

[edmagner]

The power connectors are JST 2.0

The light connectors are JST 1.0

The number is the distance between pin centers in mm - 2.0 mm between the pins on the power connector.

It's hard to find the 2.0's with pigtails on both ends - normally see them with one pigtail and a bare socket

Bruce at Cincyslots has these listed

https://race.cincyslots.com/shop-124-132-slot-car-carrera-scalextric-ninco-fly-cars-analog-digital-nsr-slot-race-set-track-evolution-exclusiv-rehnbahn-sloter-nascar-monogram-controller/carrera-digital-connector-female/

https://race.cincyslots.com/shop-124-132-slot-car-carrera-scalextric-ninco-fly-cars-analog-digital-nsr-slot-race-set-track-evolution-exclusiv-rehnbahn-sloter-nascar-monogram-controller/carrera-digital-connector-female/

I've gotten these from Frankenslot that have a high quality, highly flexible silicone wire

https://www.slotcar-factory.de/shop/...ung::1138.html

https://www.slotcar-factory.de/shop/...ung::2391.html

[Bluevista]

I'm pretty sure the light connectors are 1.5 mm and the motor is 2.0, the only sizes I have and use for Carrera.

You can buy all the PST connectors on Amazon for pennies a piece , I have enough of the things to choke a horse.
The same goes for the headlight and tail light chip and diode LED's.