I've had an Excaliber chassis sitting around for years.

I finally decided to do something with it, and discovered I no longer have a Ninco motor pod. I tried 3D printing one, three times. I paid for one, got a free one because the first was so bad, then tried a different library that has a better printer, but none of them came out good enough to use, e.g.:

So a few questions.
If you've used this Parma chassis, how happy were you with the results?
Has anyone tried using something other than a Ninco motor pod with it?
Does anyone have a Ninco motor pod they'd be willing to sell or trade?
Thanks,
Ron
I finally decided to do something with it, and discovered I no longer have a Ninco motor pod. I tried 3D printing one, three times. I paid for one, got a free one because the first was so bad, then tried a different library that has a better printer, but none of them came out good enough to use, e.g.:
So a few questions.
If you've used this Parma chassis, how happy were you with the results?
Has anyone tried using something other than a Ninco motor pod with it?
Does anyone have a Ninco motor pod they'd be willing to sell or trade?
Thanks,
Ron
Comment