Announcement

Collapse
No announcement yet.

Do you know your grub screws?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Do you know your grub screws?

    I recently purchased a used FLYSLOT chassis and noticed the front axle will accept grub screws, which it does not have now. Does anyone know the size that will fit? I need to order them since I don't have any now.

  • #2
    You might check with the folks at Slot Car Corner. They sell convex tip grubs for use in adjusting axle height.

    Comment


    • #3
      They would take the M2 (0.9mm) grub screws probably want 4mm - 6mm long ones I am guessing
      Dangermouse to the rescue.

      Comment


      • #4
        M2 was my guess also. The holes above the axle look 2mm wide, but the holes below the axle are smaller. I guessing that I may have to open them up with a drill bit to get them to accept a grub screw. Thank you DM.

        I'll be sure to check Slot Car Corner for them Mickey.

        Comment


        • #5
          We offer M2 oval point set screws in several lengths for front axle height adjustment. Here is a link:

          M2 Oval Point Set Screws

          We will have pictures on the website shortly; however, we do have plenty of oval point set screws in stock.



          www.slotcarcorner.com
          email: [email protected] phone: 603.753.6263

          Comment

          Working...
          X
          UA-149438709-1