Announcement

Collapse
No announcement yet.

Scale Car Garage - 1/32 Scale 1955 Porsche Speedster Pt 2

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Kitmen
    replied
    Scott, thanks so much for your wonderful post! You're quite correct, in retrospect, I should have had better planning and either used two short lengths of square tubing to create a proper gap under the centre of the axel, or as you suggest, place two square or round brass tubes perpendicular to the axel to allow for the guide wires!

    Pete, no problem! Your offer is very generous thank you!

    Thanks again for your wonderful support!
    😀
    John

    Leave a comment:


  • PetesLightKits
    replied
    John,
    Your post of part 2 reminded me that I promised you a box of goodies. Honestly, I completely forgot but will get some things printed up and sent out.

    Peter

    Leave a comment:


  • noddaz
    replied
    Wonderful video as always! But please clamp what you ae drilling to the counter instead of holding it in your hand.
    Also I have seen where people solder short brass tubes to the chassis as wire guides. Looks nice and neat!
    Please continue building!

    Scott

    Leave a comment:


  • Kitmen
    started a topic Scale Car Garage - 1/32 Scale 1955 Porsche Speedster Pt 2

    Scale Car Garage - 1/32 Scale 1955 Porsche Speedster Pt 2

    Please join me for part two of building a 1/32 scale 1955 Porsche 356 Speedster from a highly detailed model kit by Tomy!



    Any and all comments are more than welcomed!

    Thanks
    😀
    John
Working...
X
UA-149438709-1