I'm having an issue with the braid plate on the above car. After several laps on my track (stock SCX C4 GT analog track set extended to lengthen the straight-aways), the car jumps out of the slot either going into or out of the grand chicane. When I inspect the braid plate, I find that it has slipped forward slightly. I push it back into place and the car runs a few more laps but then repeats. This is maddening. I only have one other Sclaextric car (Bugatti Veyron) and it does not have the issue. Any idea as to how to remedy?
Announcement
Collapse
No announcement yet.
Scalextric Braid Plates on F1 McLaren MCL32
Collapse
X
-
Remove the plate and using a small flat tip screw driver you can slight pry up on the metal contact to take the slop out of the guild plate. also make sure it is clicking /locking into place on the guild.THE other Vancouver aka Vancouver Washington across the river from keep Portland weird....
Member NASTE (Northwest Association of Slot Track Enthusiasts)
-
Just a little will do. If you go to far you risk breaking the guild or cause the metal plate taps to pull out from the guild. You just want to take out the slop and make a tight fitTHE other Vancouver aka Vancouver Washington across the river from keep Portland weird....
Member NASTE (Northwest Association of Slot Track Enthusiasts)
Comment
Comment